Deep Groove Ball Bearings FAG 62202 -2RSR

The 62202 -2RSR deep-groove ball bearing from FAG Rolling Bearings, measuring 15 x 35 x 14 mm, offers a compact design and protection against dust and moisture on both sides.

The 62202 -2RSR deep groove ball bearing is a single-row rolling bearing made from standard rolling bearing steel (100Cr6) with a bore of 15 mm, an outer diameter of 35 mm and a wider design measuring 14 mm in width. Compared to narrower bearing variants, this version’s greater width allows for a higher grease capacity. Fitted with a sturdy sheet steel cage and standard radial clearance, this version primarily accommodates radial forces as well as moderate axial loads.

What is the 62202-2RSR deep groove ball bearing suitable for?

This deep-groove ball bearing is primarily used where compact shaft diameters of 15 mm are subject to demanding environmental conditions. Thanks to its factory-fitted seal, this design proves its worth in rotating assemblies, drive units and enclosed mechanical engineering structures. The cylindrical outer ring, which has no groove or flange, fits precisely into standard bores. Designers use this design as a load-bearing fixed or floating bearing for continuous rotational movements.

What is the function of the double-sided 2RSR seal?

The 2RSR seal, which contacts the raceways on both sides, effectively protects the raceways against the ingress of dirt particles, dust and splash water. At the same time, the sealing lip serves to minimise the escape of lubricant during operation. In combination with the permissible temperature range of -20 to +100 degrees, this bearing is suitable for enclosed assemblies without an external relubrication system. The contact design results in slightly more friction than with cover plates, which is offset by the high level of protection provided.