Deep Groove Ball Bearings FAG 6019 -Z

The FAG 6019-Z deep-groove ball bearing, with dimensions of 95 × 145 × 24 mm, accommodates radial loads and provides protection against dirt particles on one side.

The 6019-Z deep groove ball bearing is a single-row rolling bearing made from 100Cr6 bearing steel, designed for predominantly radial loads as well as moderate axial forces. With an inside diameter of 95 mm, an outside diameter of 145 mm and a width of 24 mm, the FAG design complies with the standardised tolerance class P0 (ABEC 1). A sheet steel cage guides the rolling elements evenly into the deep raceways. The design is suitable for enclosed mounting spaces and stationary shaft mountings.

In which applications is the 6019-Z deep-groove ball bearing used?

This deep-groove ball bearing is suitable for rotating shafts in mechanical engineering and in enclosed gearbox housings. Designed for operating temperatures ranging from –30 to +150 degrees, the bearing covers a wide thermal range. Designs with a shaft diameter of 95 mm utilise the single-row design to accommodate radial forces. In appropriate bearing arrangements, this type can be used as a non-locating or locating bearing.

What is the function of the bearing’s single-sided Z-cover?

The -Z designation refers to a non-abrasive cover plate made of sheet steel on one end face. This design shields the interior of the bearing from coarse particles, whilst the open opposite side allows lubricant to enter from inside the housing. The 6019 -Z deep groove ball bearing can therefore be operated in oil- or grease-lubricated housings. The standard radial bearing clearance provides the appropriate radial gap at standard operating temperatures and with typical fit selections.