L-section Rings FAG HJ314 -E

The HJ314-E angular ring from FAG Wälzlager is used for axial guidance in cylindrical roller bearings with dimensions of 70 x 97.5 x 15.5 mm.

The HJ314-E angular ring from FAG Rolling Bearings is an accessory part for cylindrical roller bearings, manufactured from rolling bearing steel. As a thrust washer with a flange, this ring extends cylindrical radial bearings to provide an additional axial guidance surface. With an inside diameter of 70 mm, an outside diameter of 97.5 mm and a width of 15.5 mm, the ring fits the corresponding bearing sets exactly. Design engineers use this component to provide axial guidance for shafts and to simplify assembly procedures.

What is the HJ314-E angular ring suitable for?

This ring is primarily used in combination with cylindrical roller bearings from the NJ series. By fitting the angular ring, a single-sided support bearing is transformed into a fixed bearing capable of accommodating axial forces in both directions. This proves particularly useful for gearbox shafts and industrial drives with defined shaft guidance. Compared to bearings with integral flanges, the split design allows for easier installation and a tight fit on the shaft.

What characterises the -E design for this angular ring?

The suffix ‘-E’ refers to the reinforced design, which is tailored to the internal geometry of modern cylindrical roller bearings with higher load-carrying capacity. The ring, made of through-hardened steel, has precisely ground side surfaces that ensure exact run-out on the bearing inner ring. During installation, the flat end face rests directly against the inner ring of the bearing. The component requires no reworking and fits positively into the existing shaft assembly.